Going to try a 3D printed dead tree (resin) for the WW2 US repair depot. It will take a little over 19 hours to print. So tomorrow I'll get to see if it's a hit or a bust. If this is a hit then I'll start back on the diorama while working on the railway gun.
Well while I was sleeping the vat ran out of resin. So on that note, I'll be using the tree but the upper branches will look sawed off and I may hang an engine from one of the branches.
The pictures are after I sprayed primer black
The tree is being painted (still painting as this will be thin layers)
I'm done painting and anything else will be added after its placed on the diorama
