I'm going to give it a shot printing a dragon which is 11 separate prints that need to be glued together.

Head and 3 other parts printed.

Printing the wings proved to be a bit of a pain but was able to get the upper wings to fit on the build plate. The tail was nice and detailed as well.

Putting all the parts together.

Sprayed primer black

Sprayed Testors color shifting paint from a rattle can.

For the spikes I went with Metallic Black.

The claws and horns are Dark Bronze, mouth pale burnt metal and tongue is metallic rust with clear red over both.

Then two different oil washes, Sepia and black to give an older look and to bring out the shadows. Last was dry brushing metallic blue over the whole dragon and a good coat of clear gloss